Gleamworks

Acura Paint Protection Film

PAINT PROTECTION FILM FOR VANCOUVER RICHMOND BURNABY SURREY LOWER MAINLAND, BC

WHAT IS PAINT PROTECTION FILM (CLEAR BRA) ?

Acura paint protection is a fitted layer of clear film placed over painted panels that take stone hits, road spray, sap, and light scuffs. It gives your paint a sacrificial surface, while keeping the factory colour visible. Gleamworks installs XPEL, STEK DYNOshield, and SunTek film in gloss, satin, and matte finishes. We can cover only the front impact areas or wrap the full body. Vancouver receives 1,119.2 mm of rain in a normal year, and rain leaves mineral marks when it dries on dirty paint. Film does not stop every mark, and it does not replace washing. For MDX and RDX owners, the main choice is how much of the front end, rocker area, and loading edge see daily use. Manufacturer film warranty can run up to 9 years.
System x accredited installation center
Gtechniq Logo
carpro approved detailing centre
revivify coatings logo

BENEFITS OF PAINT PROTECTION FILM

An Acura paint protection package begins with Gleamworks’ Light Package, from $1,299. It covers the half hood, half fenders, mirrors, and front bumper. Repainting one damaged panel at a Metro Vancouver body shop typically runs in the range of $600–$1,500. On the Sea-to-Sky Highway, grit often hits the same front areas the package covers. The larger issue here is what follows a chip. January’s mean daily low is 1.4 °C, so water can enter exposed paint, freeze, and expand instead of staying put through a dry deep-cold winter. That matters on Canadian-built MDX and RDX models that see regular BC road use. The film takes the first hit on covered panels; it does not make your paint immune to damage. Compare the panels you drive into grit with the cost of repainting even one of them.

1

+

Happy Clients

1

%

Customer Satisfaction

PRICING FOR Acura

In the car graphics below, the areas in red indicate coverage area, not colour. Paint protection film comes is transparent and can have either a gloss or matte finish.

 
paint- protection film standard package

PPF LIGHT PACKAGE

  • Covers half hood
  • Covers half fenders
  • Covers mirrors
  • Front bumper

From $1299

GET A QUOTE
paint protection film ultimate package

PPF GOLD PACKAGE

  • Covers full hood
  • Covers full fenders
  • Covers mirrors
  • Front bumper
  • Headlight

From $1799

GET A QUOTE
paint protection film platinum package

PPF PLATINUM PACKAGE

  • Covers full vehicle.

From $4699

GET A QUOTE

ADDITIONAL OPTIONS

BAGGAGE REST

paint protection film rocker cover

ROCKER COVERS

DOOR SILLS (PAIR)

FAQ

Book Your Ceramic Coating Today – Protect Your Investment for the Next Years.

How long does it take to apply paint protection film?

There is no honest fixed install time for every Acura. Coverage level, panel condition, trim shape, and add-ons such as rocker covers or a loading-lip guard change the work. We inspect the paint and agree on coverage before we set the pickup plan. Vancouver records measurable precipitation on 169.5 days in an average year, so we do not rush a film job around a brief dry spell. Gleamworks has protected 2,000+ vehicles, including the MDX, RDX, TLX, and Integra models common on local roads. If your paint has swirl marks, spider-webbing, or oxidation, ask us to assess correction before you choose film coverage.

Are there any special care instructions for paint protection film?

Rain is not a wash. November alone averages 174.6 mm of rain here, and dried road film can leave mineral spots on the surface. Wash your Acura regularly, especially after brine or salt collects in the wheel wells and along the rockers. Use clean wash tools and avoid grinding grit across the film. Remove cedar or fir sap, cottonwood fluff, and spring pollen before they sit through repeated rain. If you are pricing Acura car detailing, ask for a wash plan that includes the lower doors, rocker panels, and rear hatch or trunk loading area. MDX and RDX owners who carry skis, bikes, pets, or cargo should also check the loading edge for scuffs. Routine washing keeps dirt from building up; leaving it there makes later cleaning harder.

What happens if the film gets scratched?

A scratch needs an inspection, because the key question is whether it stops in the film or reaches the paint beneath it. Do not assume every mark will disappear, and do not rub hard at a dirty scratch. December’s mean daily low is 1.2 °C, which puts exposed chips in the same wet freeze-thaw cycle that can worsen damage at the panel edge. On a TLX or Integra, that can matter on the lower bumper and hood line after winter road grit. STEK DYNOshield can carry a 12-year extended warranty when STEK Final Coat is added. Acura ceramic coating adds a thin, hard sacrificial layer that resists light marring, but it does not replace film where stones strike. Book an inspection before a surface mark turns into an exposed paint chip.

Can paint protection film be removed?

Yes. A trained installer can remove paint protection film when it reaches the end of its useful life, when a panel needs repair, or when you want new coverage. We inspect the edges, paint condition, and any prior repair work before we start. The area averages 36.6 cm of snow each year, and winter travel adds sand and salt to the panels many MDX owners protect first. Gleamworks’ Platinum Package starts at $4,699 for full-vehicle coverage. A full respray in this market typically falls in the range of $5,000–$12,000. Removal is a practical choice when you need panel work, while full coverage is a separate decision based on how long you plan to keep the paint exposed.

What kind of vehicles can use PPF?

PPF suits every Acura model listed here: MDX, RDX, TLX, and Integra. The useful coverage changes with how you drive it. A Gold Package starts at $1,799 and covers the full hood, full fenders, mirrors, front bumper, and headlights. That makes sense for cars that see regular highway runs, while rocker covers and door-sill pairs suit busy family use or frequent passengers. Whistler trips add 120 km of highway grit each way, with the Sea-to-Sky Highway putting stones and wet road spray on the front end. Full coverage may suit an Acura that spends more time on these roads or parks outside. Choose front coverage when those panels take the risk, then add rockers or the loading lip where your use calls for it.

What areas of Vancouver do you serve?

We provide paint protection film to Vancouver, Richmond and Lower Mainland clients.

Gleamworks Detailing & Ceramic Coating
By appointment only.
5-8855 Laurel Street,
Vancouver, BC, Canada V6P 3V9.
View a map and directions.

How much does Acura PPF cost in Vancouver?

$1,299 is the starting price for Acura paint protection film at Gleamworks. The Light Package covers the half hood, half fenders, mirrors, and front bumper. Gold starts at $1,799 for full hood and fenders coverage, while full-vehicle Platinum protection starts at $4,699. An MDX or RDX usually needs more material than a TLX or Integra.

Is Acura dealer paint protection worth it?

Usually, take a dealer package only if it names the film brand, covered panels, warranty, and installer. Gleamworks installs XPEL, STEK DYNOshield, or SunTek and sets out the coverage before work starts. Any price gap should buy clearer panel coverage, proper paint prep, and an installer you can return to if an edge needs attention.

What are the downsides of Acura PPF?

The main drawbacks are cost, prep time, and the fact that film can still take damage. Deep impacts can cut or tear it, and it will not stop every dent. A cheap install can look worse than nothing, with trapped dirt, visible edges, or poor alignment. Film also needs normal washing and care to keep it looking clean.

How long does Acura PPF last?

Expect long-term protection, not permanent film. XPEL, STEK DYNOshield, and SunTek installations carry manufacturer coverage for up to 9 years. A 12-year extended warranty is available when STEK Final Coat is added. Rock strikes, poor washing, neglected edges, and frequent grit-heavy highway driving can shorten its real-world life. Warranty coverage does not cover every impact or stain.

What ruins Acura paint protection film?

Heat, abrasion, and bad wash habits do the most harm. Do not pick at edges, scrub bugs or sap with a dry towel, use harsh solvents, or aim a pressure-washer tip directly at seams. Avoid stiff brushes and abrasive compounds. Clean bird droppings, tree sap, and road film promptly, since leaving them on the surface makes removal harder.

Can I wash Acura PPF at car washes?

Yes, but hand washing is safest and touchless bays are the better automatic option. Avoid brush tunnels because dirty bristles can scour the film and trim. A pressure washer is fine when used with distance and care around edges, badges, and seams. Ask the shop before washing a newly installed film, then use clean mitts and soft drying towels.

Is Acura PPF worth it in Vancouver?

Yes, especially for an Acura that sees wet roads, winter trips, or regular highway driving. Vancouver receives 1,159.5 mm of precipitation across 169.5 days with measurable precipitation each year. Rain that dries can leave mineral spotting, while road grit chips bumpers and rocker panels. Film takes the first hit on the areas that face that wear.

Does Acura PPF help at lease return?

It can reduce avoidable paint reconditioning at lease return, provided the film is clean and its edges remain sound. A single panel repaint at a Metro Vancouver body shop typically costs in the range of $600–$1,500. Keep the install paperwork and inspect the film before return. Film does not erase existing damage or override the lease company’s inspection terms.

REQUEST AN APPOINTMENT ONLINE

After you submit the form, a representative will call you back with the information you’ll need to make an appointment.





    Please prove you are human by selecting the key.

    ▲
    Cart
    Call Now